The technical data of the tube assembly are supplied with the assembly. 5 2 /72/82/10 2 : Anode mechanically stress-relieved These tube assemblies are shown with (3 ~ ) in the list. OPTILIX tube assemblies without the designation ”L” (without LOADIX) are equipped with 3-phase stators and can only be operated on generators with starters that have been developed specifically for this. Cable horns 40° to the radiation outletġ17: Housing for tubes with100 mm anode and 150 Hz - 300 Hz rotation, Cable horns 90° to the radiation outletġ02: Housing for tubes with 100 mm anode. The designation of the x-ray tube assembly comprises the following.ġ00: Housing for tubes with 100 mm anode. The tube housing with built-in x-ray tube is called x-ray tube assembly. ∙ The safety notes and protective measures in the corresponding generator documents must be strictly observed. 3 - 2Ĥ _Changes to previous version _ 4 - 1 Startup of the tube assembly with high voltage. 2 - 5 Replacement of the additional filter. 2 - 4 Pre-filtering of the x-ray tube assembly. 65 kVp (IEC 522/1976) Beam quality half value layer (H.V.L.) better than 1.7 mm Al 65 kVp Focal spot 0. 1 - 2Ģ _Installation _ 2 - 1Ĭonnection to the tube assembly (on the stator side). X-ray tube 800-000 G, grid controlled, single focus DQG X-ray Tubehead Oil immersed, shielded Minimum filtration permanently in the beam 2.0 mm Al equiv.
0 Comments
Leave a Reply. |